Recently Viewed:
Related products
-
Accessories
HANGERS/SET (H1510)
1999-2006 GM/Chevrolet 1500 series trucks (-2″ drop)
Designed to work directly with CalTracs. These hangers replace the original front hangar plates.
These front hangars are intended for use when aftermarket lowering hangars used to lower the truck will not allow the use of CalTracs on the spring. This product will lower the truck 2″ like most aftermarket hangars, but are designed to work directly with our CalTrac bar kits.
Includes (2) two hangers and required hardware.
NOTE: These will not fit long bed models or 454SS. without modification
(0 reviews) -
Accessories
U-Bolts, Square/set, 3″x15″ (SQ300x1500)
SET OF FOUR SQUARE U-BOLTS w/hardware
3″ axle diameter x 15″ long, axle BELOW springs.
Square U-bolts, Grade 5 material, zinc plated, 9/16″ diameter. Set includes 4 U-bolts, plates, nuts and washers.
SQUARE U-BOLTS (spring OVER axle): We recommend torqueing truck/square u-bolts to 90-100 foot lbs. After running the vehicle down the track a few times, we also recommending checking the u-bolts and readjusting if necessary. Please see CalTracs Installation Guide for more info.
(SQ300x900 shown)
(0 reviews) -
Accessories
TIE DOWN BRACKETS/PAIR (TD-145)
TIE DOWN BRACKETS – SET OF TWO, 45 degree angle
One of the little annoyances many racers have is finding a place on their race car to tie it down onto a trailer or hauler without damaging the car and having to crawl under to find a spot for a strap/hook to load/unload/load again after a long day racing….
IF YOU HAVE CALTRACS, YOU HAVE TIE DOWN POINTS!
Secure your vehicle to a trailer or hauler with EASY TO INSTALL/EASY TO ACCESS Tie Down Brackets. Designed to bolt onto your CalTracs Mounts and LEAVE ON without affecting performance. Can be used in different configurations, depending on your needs.
NOTE: Does not include straps. Fits STANDARD CALTRACS (all cars).1/4″ Zinc-Plated Steel, 45 degree angle. Overall size: 5-1/8″ x 4″; Hole is 1-3/8″ diameter. Manufactured in USA by Calvert Racing.
(0 reviews) -
Accessories
SPRING SLIDERS for Calvert Springs (SL-300CR )
SET OF TWO SPRING SLIDERS
Designed to fit Calvert Leafsprings installed on ALL CARS & TRUCKS (except Chevy Bel Air). Outside diameter aluminum bushings: 1″.
May also fit most Chrysler factory springs due to rear bearing size.
Heavy Duty roller bearings keep the leafspring and body from binding up during suspension movement. Replaces the existing shackles.
(0 reviews)
